Iqinvision Alliance-mx User Manual

1IQeye Alliance-mxVandal-Resistant IP CameraInstallation and Operating Instructions

101. Insert the IQtools CD into the CD drive of the PC. Once the CD starts, run IQfinder either from the CD by clicking “Scan for IQeye cameras on m

113/5 Year Limited Hardware WarrantyWarranty CoverageIQinVision, Inc. (“IQinVision”) warranty obligations are limited to the terms set forth below:IQi

1233122 Valle Road San Juan Capistrano, CA 92675-4853 USA | phone +1 949 369 8100 | fax +1 949 369 8105 | www.iqeye.com901-0243 Rev D

2Contents1 Unpacking 32 Service 33 Description 44 Installation 45 Parts List 46 Mounting Options 57 Removal of Dome Cover 68

31 UnpackingUnpack carefully. This is an electromechanical device and should be handled carefully. Check to ensure the following items are included:

43 DescriptionThe Alliance-mx H.264 Standard and High Definition dome cameras provide exceptional image quality in the most demanding indoor / outdoo

56 Mounting OptionsThe Alliance-mx camera is designed to be used in one of the following configurations. 1. Surface mounted to a plenum or other dura

67 Removal of Dome Cover1. Using the supplied Torx T-20 security wrench, loosen the three tamper-proof screws holding the dome cover to the enclosur

74. To ensure the gasket is sealed gently pull back on the Ethernet cable as shown in Figure 8.3 before mounting the enclosure to the wall or ceiling

89 Connect Camera1. For the Alliance-mx IQM30 & IQM31 series cameras, route and connect the Power-over-Ethernet cable to the Ethernet connec

911 Factory Reset1. Press and hold the “Reset” button for 10 seconds as illustrated in Figure 11.1.12 Complete the Dome Camera Installation1. Atta