Iqinvision Alliance-pro Series User Manual

1IQeye Alliance-pro SeriesVandal-resistant IP CameraInstallation and Operating Instructions

10c. If audio, I/O, and continuous analog video out connections are being used, attach them to the appropriate terminals on the Audio / Triggers

11c. Adjust the tilt of the camera by loosening the tilt angle lock screw as shown in Figure 10.1 and position the lens to the desired position. Wh

1211 Reboot and Factory Restorea. Rebooting - Depress the reboot key for 2-3 seconds then release. b. Restoring to Factory Default - Press the “Fact

1313 PC Configuration of IQeye Alliance-proPLEASE NOTE – The default user name for all IQeye devices is “root” and the default password is “system”.I

14c. The “Assign IP” window allows the IP Address, Subnet, and Gateway of the camera to be changed. It also allows the camera to be configured to D

15e. To perform further configuration of the camera click on the “Setup” tab.NOTE: The default username is “root” and the default password is “system

1614 Auto Focus Lens Zoom & Focus AdjustmentThe auto focus lens greatly reduces installation time allowing for remote zoom and one-touch focus con

174. One-Touch Focus: Use the one-touch focus button to automatically focus the lens based on the detail within the blue focus window. 5.

18NOTES:

19NOTES:

2Contents1 Unpacking 32 Service 33 Description 44 Installation 45 Parts List 56 Mounting Options 67 Removal of Dome

2033122 Valle Road San Juan Capistrano, CA 92675-4853 USA | phone +1 949 369 8100 | fax +1 949 369 8105 | www.iqeye.com901-0278 Rev D

31 UnpackingUnpack carefully. This is an electromechanical device and should be handled with care. Check to ensure the following are included:IQA3xNI

43 DescriptionThe IQeye Alliance-pro Series is an advanced network dome camera available in multiple resolutions up to 5 megapixel resolutions. With

55 Parts ListFigure 5.1 and Figure 5.2 depict the major camera assembly parts included:IQA3xNI and IQA3xWI Series a. Alliance Mounting Plateb. Allianc

66 Mounting OptionsAlliance-pro cameras can be mounted in one of two configurations, wall or ceiling. Both mounting configurations are shown in Figur

77 Removal of Dome Cover and Camera Assemblya. Using the supplied Torx T-20 security tool, loosen the four tamper-proof screws holding the dome c

88 Install Interior Mounting Platea. Position the supplied mounting template on the surface in the location where the camera will be installed. Tr

9a. Power the camera using either direct power or Power-over-Ethernet. 1. Direct Power: Connect either a 12-24VDC or 24VAC power source to the